// PrintTime_BlinkDelay_Tasks.ino
// Prints and Blinks using delay (bad)
/*
   (c)2019 Forward Computing and Control Pty. Ltd.
   NSW Australia, www.forward.com.au
   This code is not warranted to be fit for any purpose. You may only use it at your own risk.
   This generated code may be freely used for both private and commercial use
   provided this copyright is maintained.
*/
// install SafeString library from Library manager or from https://www.forward.com.au/pfod/ArduinoProgramming/SafeString/index.html
#include <loopTimer.h>
// the loopTimer, BufferedOutput, SafeStringReader and millisDelay are all included in SafeString library V3+

int led = 13;

// the setup function runs once when you press reset or power the board
void setup() {
  Serial.begin(9600);
  for (int i = 10; i > 0; i--) {
    Serial.println(i);
    delay(500);
  }
  // initialize digital pin led as an output.
  pinMode(led, OUTPUT);
}

// the task method
void blinkLed13() {
  digitalWrite(led, HIGH);   // turn the led on (HIGH is the voltage level)
  delay(1000);                       // wait for a second
  digitalWrite(led, LOW);    // turn the led off by making the voltage LOW
  delay(1000);                       // wait for a second
}

// the task method
void print_ms() {
  Serial.println(millis());   // print the current ms
  delay(5000);              // wait for a 5 seconds
}

// the loop function runs over and over again forever
void loop() {
  loopTimer.check(Serial);
  blinkLed13(); // call the method to blink the led
  print_ms(); // print the time
}